旋转剥皮机

设备组成：

 

旋转剥皮机由机体、夹持装置、剥皮装置、旋转装置、剥皮长度设置装置、可编程控制器等组成。

 

工作原理

 

通过夹持气缸将工件夹紧后，剥刀收紧，旋转气缸将钢丝表层胶皮切断，然后剥皮气缸将表层胶皮剥掉，最后夹持气缸复位，进入待机状态。

 

设备特征

 

该机设计巧妙，用于剥离规定长度的涂塑钢丝绳和直丝管和以往剥皮不同的是旋转剥皮，剥皮效果好且剥离直径大，工作效率高，故障率低，使用寿命长，互换性强，适用于不同规格的涂塑钢丝绳和直丝管剥皮工序。

The rotary skinning machine consists of an airframe, a clamping device, a skinning device, a rotating device, a skinning length setting device and a programmable controller.

The working principle of

After clamping the workpiece through the clamping cylinder, the stripping knife tightens, the rotating cylinder cuts off the steel wire surface rubber, then the peeling cylinder strips the surface rubber, and finally the clamping cylinder resets and enters the standby state.

Device characteristics

This machine is designed skillfully, used to peel the specified length of plastic coated steel wire rope and straight wire tube and the previous peeling is different from the rotation peeling, peeling effect is good and peeling diameter, high efficiency, low failure rate, long service life, strong interchangeability, suitable for different specifications of plastic coated steel wire rope and straight wire tube peeling process.